The manual of the LED Rope lights
1 We can't turn on the rope light when it's still flocked or stocked in the carton; We can cut the rope light on where there is a cut mark, otherwise, one unit will can't be turn on.
2 During installing the rope light, we must keep the wires outside tidiness so as not to be short circuit, and the power cord will be connected the wires inside the rope light one to one.
3 The rope light can be turned on when everything is ok, for example, the power plug is connected the rope light rightly, the rope light is fixed tightly, the end cap is covered the end of the rope light, and so on.
4 When it's very cold, please turn on the rope light for some minutes to be soft, so that it is more convenient for installing the rope light.
5 During the installing the rope light, shaking/bumping/bending can't be allowed.
6 The end of the rope light have to be covered with the End cap which is full of the silicon, so that it can be water-proof using outdoor.
7 The rope light with the same technological parameters and the same style can be serial connected together, but the max length is depends on the different style, as a rule, the max length of the round/flat/square two wires is 100 meters, the max length of the flat 3 wires/4 wires/5 wires is 50 meters.
8 The connections have to be water-proof with PVC, silicon, transparent pastern etc..
9 The rope light can't be used in water, the flammable, the explosible and the other bad environmental.
10 During installing the rope light, don't use the steel/copper wire to fix it, otherwise it maybe cut down or get into the rope light then become short circuit
11 The Voltage input the rope light must be matched the voltage marked in the rope light.
12 During turning on the rope light, the environment had better keep cool and tidy.
13 Please cut the dilapidation to prevent from the danger's happening.
14 The rope light can be flashing, chasing with the special controller.
15 From the linker to the plug for indoor use.
16 Please pay more attention that if the rope were fixed on don't touch the linker and controler so hard! |
|
|
|
|
